RS type flexible sleeve expansion jointDetailed product description：

Installation data sheet for RS type flexible sleeve type expansion joint: (Product pressure according to user needs: 0.6-4.0Mpa)

Nominal diameter DN	length			Weight （kg）
	Minimum installation length L	Installation length L	Maximum installation length L
forty	one hundred and forty	one hundred and sixty	one hundred and eighty	eight point three
fifty	one hundred and forty-five	one hundred and sixty-five	one hundred and eighty-five	ten point eight
sixty-five	one hundred and forty-five	one hundred and sixty-five	one hundred and eighty-five	thirteen point six
eighty	one hundred and sixty	one hundred and eighty	two hundred	seventeen point two
one hundred	one hundred and seventy	one hundred and ninety	two hundred and ten	twenty point four
one hundred and twenty-five	one hundred and seventy	one hundred and ninety	two hundred and ten	twenty-four point nine
one hundred and fifty	one hundred and seventy-five	one hundred and ninety-five	two hundred and fifteen	thirty-one point eight
two hundred	one hundred and eighty	two hundred	two hundred and twenty	forty-two point six
two hundred and fifty	two hundred and thirty-five	two hundred and sixty	two hundred and eighty-five	fifty-nine point five
three hundred	two hundred and fifty	two hundred and eighty	three hundred and ten	seventy-three point eight
three hundred and fifty	two hundred and sixty-five	three hundred	three hundred and thirty-five	ninety-seven point one
four hundred	two hundred and eighty	three hundred and twenty	three hundred and sixty	one hundred and twenty-three
four hundred and fifty	two hundred and ninety-five	three hundred and forty	three hundred and eighty-five	one hundred and forty-six
five hundred	three hundred and ten	three hundred and sixty	four hundred and ten	one hundred and seventy-six
six hundred	three hundred and forty	four hundred	four hundred and sixty	two hundred and forty
seven hundred	three hundred and seventy	four hundred and forty	five hundred and ten	three hundred and thirty
eight hundred	four hundred	four hundred and seventy	five hundred and forty	four hundred and forty
nine hundred	four hundred and thirty	five hundred	five hundred and seventy	five hundred and thirty-six
one thousand	four hundred and forty	five hundred and twenty-five	six hundred	six hundred and seventy-five
one thousand and two hundred	four hundred and seventy-five	five hundred and fifty	six hundred and twenty-five	nine hundred and ninety-eight
one thousand and four hundred	five hundred	five hundred and eighty	six hundred and sixty	one thousand three hundred and sixty-seven
one thousand and six hundred	five hundred and thirty	six hundred and ten	six hundred and ninety	one thousand nine hundred and eight

Instructions:
1. The RS type flexible sleeve type expansion joint solves the problem of no deflection angle in the original sleeve type expansion joint, and the maximum deflection angle of this product can reach 5.85 degrees;
2. The length values in the table are all values without deviation angle;
3. This expansion joint is sealed with a rubber ring and cannot withstand axial tension. It is usually installed on a straight pipeline. If installed near bent or T-shaped pipes, pipe supports should be set up to prevent the expansion joint from being pulled off and leaking water;
4. The single disc short pipe in this expansion joint can be replaced with an outer diameter cast iron branch pipe;
5. The flange connection size adopts GB2555-81 standard;