DLM24/50 type ultrasonic level gaugeDetailed product description：

DLM24 and DLM50 are new level measuring instruments manufactured with technology imported from Kay Ray Company in the United States. They are all controlled by an eight bit single-chip microcomputer, using the principle of echo method to perform non-contact continuous measurement of the height of liquid or solid materials inside the container. According to the user's needs, the instrument can display numbers in centimeters, meters, percentages, inches, feet, and other units at will. The instrument has multiple analog outputs such as 4-20mA and three sets of alarm contact outputs.

Technical Indicators:
The on-site installation of instruments is convenient, easy to adjust, and requires minimal maintenance.
The sensors of the instrument have aluminum casing, stainless steel casing, and Kynar ® There are three types of fluoroplastic shells, most of which can be equipped with internal temperature compensation and are suitable for various occasions such as general or strong corrosion.
DLM24 can be widely used to measure various crushed solid or granular materials and liquids containing a large number of particles with a diameter of not less than 2cm.

model			DLM24	DLM50
range			7.3m	15m
blind spot			0.46m	1.50m
Digital display mode			4-digit LED (display unit user selectable)
			Ft.、in.、m、cm、％	Ft.、in.、m、％
ring realm warm degree		Controller	0～45℃
		sensor	LMS15KS：－10～＋50℃ LMS15KT：－10～＋50℃ LMS15KL：－30～＋50℃	－30～＋70℃
Distance between sensor and controller			90m	200m
biography feel device	type number		Standard Type: LMS15KS	LMS100R LMS100RSS
			Internal temperature compensation type: LMS15KT	LMS100RT LMS100RTSS
			Low temperature type: LMS15KL (with internal heating)
	shell		Kynar ® fluoroplastic	cast aluminum
	frequency		Approximately 42kHz	About 14kHz
	Beam Angle		Approximately 12 º cone angle	Approximately 7 º cone angle
	weight		About 0.6kg	About 8.8kg

Accuracy: Digital display: ± 0.5% of full range
Analog output: ± 1% of full range
Temperature additional error: ± 0.5%/10 ℃ (using temperature compensation)
Resolution: Digital display: ± 0.25% of full range
Analog output: ± 0.5% of full range
Analog output: 4-20mADC (non isolated, maximum load 750 Ω)
0～5V
0～1mA
Alarm output: three-point DPDT, contact capacity: 2A 220V AC resistive
·Method 1: Three independently adjustable relays, with action points adjustable between 2% and 99% of the range (with a switching difference of 1% of the range).
·Method 2: Two independently adjustable relays, with the operating point adjustable between 2% and 99% of the range (with a switching difference of 1% of the range). Two relays with adjustable switching differences can be set, and the operating point can be set between 2% and 99% of the range (the switching difference is the difference between the two operating points).
Power supply: 220VAC 50Hz 60W
Sensor pressure resistance: atmospheric pressure
Connection cable: The sensor and controller are connected using American RG62A/G or domestically produced SYV-75-5-1 high-frequency cables. Two core shielded cable for temperature compensation probe: It is recommended to use RVVP0.75mm2 (65 ℃) or FNP0.8mm2 (105 ℃)