DRL Vertical multi-stage centrifugal pumpDetailed product description：

Characteristics of DRL vertical multi-stage centrifugal pump

Non self-priming vertical multi-stage centrifugal pump
All overcurrent components are made of stainless steel material
Good interchangeability of components
Save installation space
Mechanical sealing method, low noise, low vibration
The inlet is connected to the pipeline on the same straight line at the bottom of the pump using a flange connection mode

Scope of Application
Main pump of variable frequency water supply system
Ordinary water supply, boiler water supply
High pressure washing, R/O filtration device
Hot and cold water circulation
Manufacturing engineering equipment, beverage processing equipment

performance parameters

distinguish	DRL2	DRL4	DRL8	DRL16	DRL32	DRL42	DRL65	DRL90
Maximum flow rate (m3/h)	four point five	nine	fourteen	twenty-six	forty-eight	sixty-five	one hundred	one hundred and thirty
Maximum head (m)	two hundred and thirty-eight	two hundred and fifteen	two hundred and five	one hundred and ninety-seven	two hundred and thirty-four	two hundred and fifty-seven	one hundred and eighty-two	one hundred and forty-seven
Temperature of the medium used (℃)	-15~+120 ℃
Maximum operating pressure (bar)	16-25 bar
Inlet and outlet diameter (DN)	twenty-five	thirty-two	forty	fifty	sixty-five	eighty	one hundred	one hundred

Part material

Component Name	DRL2～DRL16	DR 32～DR90	Motor parameters
Impeller	STS 304	STS 304	Standard IEC three-phase motor Motor model: TEFC Protection level: IP55 Insulation level: F 3-phase 220/380V 60HZ
Defuser	STS 304	STS 304
Shaft	STS 316	STS 316
Pressure resistant cylinder (Casing)	STS 304	GC250 *
Mechanical seal (M/S)	TC/SIC/VITON	SIC/Carbon Steel/VITON

DRL vertical multi-stage centrifugal pump