BP1 series frequency sensitive variable resistor-[Quotation-data]--Shanghai Huabang Industrial Business-www.91way.com

Product name：

BP1 series frequency sensitive variable resistor

specification：

Zoom in on the image

Category：

low-voltage electrical apparatus -- rheostat

Price：

factory price

Brand：

Shanghai

Place of Origin：

China

Available Quantity：

batch

delivery cycle：

Spot goods (or inquire by telephone)

Shanghai Beiyuan Industry and Trade Co.,Ltd
+86-21-66770508
+86-13916500500

91way@163.com
13916500500(Wechat)

BP1 series frequency sensitive variable resistorDetailed product description：

The BP1 series frequency sensitive variable resistor (hereinafter referred to as the variable resistor) is suitable for use with three-phase AC wound asynchronous motors with a capacity of 22kW, 50Hz as light loads or occasionally used for heavy and light loads (such as water pumps, air compressors, steel mills, air compressors, etc.), or for repeated short-term work cycles (such as bridge cranes, lifting platforms, mining conveyors, etc. with a capacity of 2.2kW to 125kW).

Environmental conditions for use
Varistors can reliably operate under the following conditions:
1. Altitude not exceeding 4000m;
2. The temperature of the surrounding medium shall not be higher than+40 ℃ and not lower than -30 ℃;
3. The relative humidity of the air shall not exceed 85% [(20 ± 5) ℃];
4. In a medium without explosive hazards, and without gases or dust that can corrode metals and damage insulation in the medium
5. Places that are protected from rain and snow, but not filled with water vapor;
6. Places that allow for general vibrations and impacts;
7. At any angle from the vertical plane.
structural characteristics
A rheostat is a non-contact electromagnetic component that is equivalent to an equivalent impedance. During the starting process of the electric motor, the equivalent impedance automatically decreases with the decrease of high-frequency components in the rotor starting current to achieve automatic resistance change. Therefore, only a first stage variable resistor is needed to start the electric motor smoothly.
A variable resistor is essentially a three-phase reactor with a very high iron core loss. It consists of two main parts: an iron core and a coil, which are made up of several E-shaped steel plates stacked together. Steel plates are clamped with washers to maintain the distance between them for heat dissipation. The structure and installation dimensions are shown in Figure 1 and Table 1.

BP1 series frequency sensitive rheostat appearance and installation dimensions

BP1 series frequency sensitive rheostat appearance and installation dimensions:

BP1-204

BP1-205

BP1-206

BP1-208

BP1-210

BP1-212

BP1-305

BP1-306

BP1-308

BP1-310

BP1-312

BP1-316

two hundred and fifty

four hundred

three hundred and ten

four hundred and eighty

one hundred and eighty-two

two hundred and fifty-two

two hundred and thirty

three hundred and eighty

one hundred

one hundred and fifteen

one hundred and thirty

one hundred and sixty

one hundred and ninety

two hundred and ten

one hundred and twenty-five

one hundred and fifty-three

one hundred and eighty

two hundred and thirty

two hundred and sixty

two hundred and ninety

one hundred and forty

one hundred and fifty-five

one hundred and seventy

two hundred

two hundred and thirty

two hundred and sixty

one hundred and seventy-three

two hundred and five

two hundred and thirty

two hundred and eighty

three hundred and ten

three hundred and forty

two hundred and forty

two hundred and fifty-five

two hundred and seventy

three hundred

three hundred and thirty

four hundred and eleven

three hundred and twenty-five

three hundred and fifty-five

three hundred and eighty

four hundred and thirty

four hundred and sixty

four hundred and ninety

BP1 series frequency sensitive rheostat

BP1 series frequency sensitive variable resistor（schematic diagram）

Related Products：