H-JK series Hall proximity switchDetailed product description：

Introduction
The H-JK series Hall proximity switch is a new type of automated switching device made based on the Hall effect principle. This product adopts a round tube waterproof design, which meets the IEC144 standard. The external dimensions and electrical parameters are based on OMRON products from Rishi Electric Co., Ltd. in Japan. It has a wide range of applications in light industry, chemical industry, textile, printing, machinery, metallurgy, telecommunications, transportation, self-control, electronic computers and other fields. The JK series is divided into three categories according to working conditions: JK - normally open type, JB - normally closed type, JZ - self-locking type.

Characteristics
High response frequency, high repeatability, high positioning accuracy, strong anti-interference ability, and multiple protection functions. It has a working status indicator light that can be directly connected to a programming controller (PC) for high reliability and long lifespan

Technical parameters

Model number parameter

JK   JB   JZ

5002C

8002C

5002D

8002D

5020D

8020D

5050D

8050D

8100D

Power supply voltage (V)

5~24

8~30

Load current (mA)

twenty

two hundred

five hundred

one thousand

Working distance (mm)

5~7

8~11

5~7

8~11

5~7

8~11

5~7

8~11

8~11

Output low level (V)

≤0.4

≤0.5

≤1.0

Response frequency (KHz)

one hundred

fifty

Positioning accuracy (mm)

zero point zero two

indicator light

N/Y

Y

Y

Y

Polarity and surge protection

N

N

Y

Y

overheat protection

Y

Y

Y

Y

output method

NPN

NPN/PNP

Working temperature (℃)

, Ⅰ -40～+125  &n, bsp; Ⅱ -25～+85

wiring diagram



External structural parameters


1. JK, JB, JZ series all use three core sheathed cables with a length of 50cm. 2. Wiring method red: power supply (VCC); Yellow: Output (OUT); Black: Ground wire (GND). 3. Dimensions (unit: mm)

Trigger method


Instructions for Use
1. The supporting magnetic steel adopts a Φ 8 × 4 neodymium iron boron magnetic steel S-surface (with a surface magnetic induction intensity of 0.3T); Other magnetic steels can also be used, but the working distance may vary.
2. If the output polarity is not explicitly required, supply according to NPN normally open.
3. In addition to the attached drawings, the external structural parameters can also be made according to customer requirements, and the cable length can be supplied according to customer requirements.
4. Please specify the full model name when placing an order, such as H-JK5020D.