Electrical characteristics of C101G direct sliding potentiometer
Full resistance: 500 Ω -1M Ω
Full resistance tolerance: ± 20%
Impedance characteristic types: A, B, C, D
Noise: Less than 100mV
Insulation impedance: 5-15mm: More than 50M Ω at DC 100V 20mm: More than 50M Ω at DC 250V
Voltage endurance: 5-15mm: 1 minute at AC 100V 20mm: 1 minute at AC 250V
Residual resistance: Term.1~2: Less than 10 Ω Term.2~3: Less than 10 Ω
Synchronization error (dual): -40dB~0dB ± 3dB
Rated Voltage
B Linear: 4mm, 5mm: AC 50V 10mm 15mm: AC 100V 20mm: AC 200V
Other linear: 4mm, 5mm: AC 25V 10mm, 15mm: AC 50V 20mm: AC 150V
Rated power (single/double)
B Linear: 4mm, 5mm: 0.01W/0.005W 10mm: 0.03W/0.015W 15mm: 0.05W/0.025W 20mm: 0.1W/-
Other linear: 4mm, 5mm: 0.025W/0.012W 10mm: 0.015W/0.01W 15mm: 0.025W/0.01W 20mm: 0.05W/-

Mechanical characteristics of C101G direct sliding potentiometer

Force: 20~200 gf.cm
Rank sliding force (only Center Click)
Force: 30~300 gf.cm
Stop strength: 2.50Kgf.cm Min (from the base level to a point of 2mm)
Sliding handle horizontal shaking amount: 2 (2xL)/25mm Max. (L: Level length both sides)
Horizontal push-pull strength: 1.0 Kgf Min. at 10 seconds
Durability
Rotation lifespan: 5000 cycles

C101G direct sliding potentiometer