PRG-1200-H Operating end isolated safety barrierDetailed product description：

The PRG-1200-H operating end isolation safety barrier is suitable for intelligent (HART) valve positioners, electric/gas converters, etc. It transmits standard 4mA~20mA current signals from the safety side to the danger side, driving the on-site actuators to work. At the same time, the HART digital signal communicates bidirectionally between the safe and dangerous sides, and can be operated on intelligent (HART) valve positioners, electric/gas converters, etc. using a HART handheld device on both the safe and dangerous sides. This product requires independent power supply, with full isolation between the power supply, input, and output.

Main technical specifications
Working power supply: 20V-35Vdc
Number of channels: single channel
Power consumption: approximately 1.5W (24V power supply, 20mA output)
Input signal range: 4mA~20mADC, HART digital signal
Output signal range: 4mA~20mADC, HART digital signal
Allowable output load capacity: 0-650 Ω
performance metrics
Insulation strength: 2500Vac/min between the intrinsic safety end and non intrinsic safety end
Continuous 1000Vac/1 minute between non intrinsic safety ends
Output accuracy: 0.1% F.S
Temperature drift: 0.01% F.S/℃
Working temperature: -20 ℃~+60 ℃
Relative temperature: 35% to 85% RH
Storage temperature: -40 ℃ to+80 ℃
Structure and external dimensions
Product structure: 35mm rail card type,
ABS shell material,
Plug in terminal
Dimensions: 22.5 × 114.5 × 99 (mm)
Whole machine weight: 150g

Product Features
Connected to intelligent (HART) valve positioner, electric/gas converter, HART bidirectional communication isolated transmission, in compliance with EMC standards
installation site
The surrounding air should not contain any medium that corrodes chromium, nickel, and silver coatings
Applicable on-site and equipment
Zone 0, Zone 1, Zone 2, Zone IIA, Zone IIB, Zone IIC hazardous areas, suitable for intelligent (HART) valve positioners, electric/gas converters
Safety and Explosion proof Certification Parameters National Explosion proof Electrical Product Quality Supervision and Inspection Center (CQST)
Explosion proof mark: [EXia] (IIC)
Authentication parameters: Terminal (between 9.10)
Um = 250V Uo = 28V Io = 93mA
Po = 0.65W Lo = 2.4mH Co = 0.05uF

wiring diagram


Outline dimension drawing (mm)