FT10 series thermal flow switchDetailed product description：

Characteristics of FFT10 series thermal flow switch

Adjustable switch point with LED display of flow status
The switch will not be damaged if the flow exceeds the specified range
You can choose between two probe sizes: long and short
The probe and cable with a shell level of NEMA4X have anti-corrosion properties
Relay or FET switch output can reliably interface with PLC, SCADA, or alarm systems
Plastic casing made of PP/Ryton or PVDF material

Performance of FT10 series thermal flow switch
Set point range: 0.04-3fbs (0.06mps)
Factory set point: 0.2fbs (0.06mps)
Repeatability: within ± 5% of the set point
Setpoint drift: within ± 5% of the set point
Reaction time: 1-10 seconds
Viscosity range: 1-300 centipoise
Supply voltage: 12-36CDX
Power consumption: FET 50mA, Relay 70mA
FET switch parameters: 36VDC@100mA
RelayL output: 60CDX/ NAC@1A
FET output: 36VDC@100mA
Switch output: normally open, normally closed
Setpoint adjustment: potentiometer
Display: LED display
Liquid temperature range: 0-60 ℃
Pressure level: 150 psi (10 bar) at 25 degrees Celsius, with a decrease of 1.667 pdi (113 bar) per degree Celsius above 25 degrees Celsius
Probe grade: NEMA4X/IP65
Probe material: PP/PVDF
Installation thread: 3/4NPT (3/4G)
Cable specification: 8 feet (244cm), 3 wires, caliber 22gayge, with ground wire shielding and PP or PEA insulation outer sheath
C E certification: EN50082-2 immunity EN55011 emission