SZ-S type magneto electric vibration velocity sensorDetailed product description：

SZ-S type magneto electric vibration velocity sensor

After being connected with the DYZ-W vibration monitoring instrument or DYZ-L vibration intensity monitoring instrument, the SZ-S vibration velocity sensor can measure various displacements, velocities, etc. The vibration of the rotor supported by rolling bearings is transmitted to the bearing cover. The S-ZS type vibration velocity sensor installed on the bearing cover cuts the magnetic field lines through the internal motion coil and outputs voltage, providing signals to the monitoring instrument for predicting and alarming mechanical faults.
Installation position: Install vertically or horizontally on the measured vibration point, and fix the bottom of the sensor with M10 screws.

Technical parameters of SZ-S type magneto electric vibration velocity sensor:

Sensitivity: 20-50mV/mm/S ± 1% (adjusted by the user)
Frequency response (optional): 5-100 Hz, 10-500 Hz, 10-1000 Hz
Natural frequency: about 10Hz
Amplitude limit: 2mm (peak to peak)
Maximum acceleration: 10g
Installation method: Vertical; Level; Vertical and horizontal dual-use type
Temperature range: -30 ℃ to 120 ℃
Relative humidity: up to 95% non condensing
Dimensions: φ 35 × 78mm
Weight: Approximately 350g
Installation thread: M10 × 1.5

Ordering Guide:

Selection code:
SZ-S- A□□-B□□
Selection instructions:
Sensitivity A □□: 01-20mV/mm/S; 02*——30mV/mm/S； 03——50mV/mm/S
Measurement direction B □□: 0 1 * - vertical; 0 2- Level; 03- Dual use vertical and horizontal